Breezy Multi-Speed 12 Volt Fan Upgrade by Class A Customs is an insert that is used to replace the fan or install a fan into a Standard 14" RV Roof Vent.
NO Interior Garnish Ring included, this is insert only
NO Vent included, this is insert only
Housing has Rounded Corners
DOES NOT fit Fantastic Brand, Super Vent, etc.
Fits Class A Customs 14", Heng's 14" and Ventline 14" RV Roof Vents Manufactured after 2016, it may fit various models - end user will need to verify if unit will work for application.
**12 volt Power ONLY 110/115/220 volt such as in a house or generator will damage the unit**
12 volt Fan Motor
9" Fan Blade
1.8 amps of power required
DO NOT let the unit hang by wires as you will damage the unit.
Multi Speed Fan
High Velocity Air Fan System over 300% more air flow movement
Multiple Speed Fan Knob: Off / Low / Medium / High
Do not overturn knob, damage to knob will occur if too much force is used
Reversible Air Flow Switch: In / Out
Removable Fine Mesh Screen included
Manual Crank Handle to open and close RV vent lid
Some models of vents will need to move the manual crank handle box that is on the units backside, view Installation Instructions
BEFORE YOU BEGIN:
12 volt Power ONLY
TOOLS NEEDED:
Phillips Head Screwdriver
Wrench
Pliers
Scissors
1. Remove Inner Garnish Ring, Vent Handle and Screen (save screws to use again).
If your current vent has a fan you will need to remove the fan, motor and switch.
2. Align the Breezy Gear Box with the Vent Operator Shaft.
If unit does not align follow STEP A: Gear Box Adjustment Steps
3. Attach wire leads with wire nuts (NOTE: if upgrading a non-powered vent, provide power source of 12 volts DC power, using 18-gauge wire.)
DO NOT allow unit to hang by wiring.
WIRE LABELED “L” is POSITIVE and WIRE LABELED “N” is GROUND -- you can NOT switch wiring, doing so will damage circuit board
4. Place the Breezy Fan into vent frame and align the Gear Box onto the Operator Shaft.
Gently rotating the handle to seat the unit into place.
5. Secure the Breezy Fan into vent frame using two screws.
6. Reinsert Inner Garnish and secure with screws.
**** STEP A : Gear Box Adjustment Instructions
Remove both screws holding the Breezy Gear Box (save screws for later use).
On the back side of the Breezy move the Gear Box to the alternate position.
If Gear Box does not reach operator shaft, included spacer will be required.
Secure Gear Box with screws.
CAUTIONS
DO NOT allow unit to be exposed to rain, this will damage the circuit board and motor over time.
DO NOT place fan directly over stove cooking surface, deep fryer, or other appliances that use flame or intense heat.
DO NOT let the unit hang by wires as you will damage the unit.
DO NOT overturn knob, damage to knob will occur if too much force is used
WIRE LABELED “L” is POSITIVE and WIRE LABELED “N” is GROUND -- you can NOT switch wiring, doing so will damage circuit board
