Pump Features & Specifications:
WFCO Artis Water Pump Model # PDS1-130-1240E
NSF Approved Materials
12 volt: You can not put this in a house or plug into a wall - 110/115/220 volt will damage the unit.
4.0 Amp Draw @ 10 PSI
7.0 Amp Draw @ 30 PSI
Open Flow: 3.0 GPM
Shut Off: 40 PSI
Self-Priming
Dry Running - Pump able to run dry without damage
Corrosion Resistant Materials
Low Noise
Sealed Motor
Patented diaphragm
Four-chamber
Self-priming to 6 feet suction
Pump can be mounted horizontally or vertically (mount pump head down). Do NOT over-tighten screws.
Pump should be on a dedicated (individual) circuit protected by the specified fuse on indicated on the motor label.
Use 14-gauge standard wire up-to 20 feet or 12-gauge up to 50 feet from power source.
Use a 10-15 amp rated on/off switch on the positive red motor lead wire.
Motor: Permanent Magnet, totally sealed, enclosed ball bearing and thermal protection.
Water Lines should be 1/2" I.D. (13mm) Flexible hose (preferably braided or reinforced) for main lines - Pump has threaded connections.
Dimensions: 7.65" L x 3.29" W x 4.35" H
Weight: 5 lbs
YOU MUST USE A STRAINER FOR WARRANTY TO BE VALID - These pumps are for fresh water not pond, lake or sea water.
Strainer Features & Specifications:
30 mesh stainless steel screen
The water filter has 1/2 inch barb fitting on input side and 1/2 inch female pipe threads on the output side.
Protects your pump from debris which causes premature failure of your water pump
The water filter is installed on the input side of the water pump.
Class A Customs
1130 County Road 6 West
Elkhart, IN 46514
Call Us: (574) 206-0101
