Tank Measurements +/- .25" on each measurement due to manufacturing process
Installed Fittings See Photos
Two) 1.5" Female NPT Fitting - fitting is sealed to use remove membrane with razor knife
Average tank thickness .219 or 7/32" thick (just under 1/4")
Two) 1.5" Female NPT Fitting - fitting is sealed to use remove membrane with razor knife
Two) .5" Female NPT Fitting - fitting is open
Class
A Customs located in Elkhart, Indiana manufactures fresh and gray water
use tanks along with black waste water holding tanks.
great for rvs, food vendors, tiny houses, overlanding and extra water storage
Class A Customs does not carry this chemical nor uses it in the manufacturing process
Material Used To Manufacture
Material Used To Manufacture
Fresh/Gray Water Tanks & fittings made from DOW NSF International NSF/ANSI Std 61 approved Medium Density Polyethylene (MDPE) Resin
NSF Certified Materials - No Logo in Tanks
Complies with:
U.S. FDA 21 CFR 177.1520 (c)3.1a
Canadian HPFB No Objection
Underwriters Laboratories Inc.
EU, 10/2011
NSF International NSF/ANSI Std 61 (sec 4 & 5)
UV-8 Stabilization
glues do not stick to this material and easily cleaned.
U.S. FDA 21 CFR 177.1520 (c)3.1a
Canadian HPFB No Objection
Underwriters Laboratories Inc.
EU, 10/2011
NSF International NSF/ANSI Std 61 (sec 4 & 5)
Class A Customs NSF Letter - this letter has all fresh/gray tank sizes, part #'s, measurements and fittings, along with material tank is made from.
all tanks Class A Customs manufactures must be vented (allow air in/out during use), Plumbing Example and Fill Dishes
Tanks
creamy white in color can be used for Fresh or Gray water use, great
for rvs, food vendors, tiny houses, over-landing and extra water storage
Seamless
One-piece seamless construction, no seams to burst Average tank thickness: .219 or 7/32" thick (just under 1/4")
Rotatable
tank can be placed on any side but must be braced
Stain, Corrosion and Rust Resistant
Color
Creamy White in color so you can see waterline through tank, we recommend a Water Tank Monitor to check levels
Can I stack the water tanks on top of each other?
Can I put weight on the tanks?
No, do not place anything on the tanks, if you need to stack the tanks you will need a weight bearing shelf between them.
Can I put weight on the tanks?
No, do not place anything on the tanks, if you need to stack the tanks you will need a weight bearing shelf between them.
Class A Customs
1130 County Road 6 West
Elkhart, IN 46514Phone: (574) 206-0101
No comments:
Post a Comment